FINAL DRIVEIOUTPUT SHAFT
Replace the output shaft adjustment shim with a thicker one
if the contact is too low (on the flank end)
Refer to the Model Specific manual for side gear case
installation.
CONTACT TOO LOW
m
INSTALLATION
If the damper spring was removed, install it according t o the
following procedure:
SPRING COMPRESSOR
Place the damper spring and damper cam over the shaft.
Install the damper spring compressor and compress the spring,
then install the snap ring securely.
FINAL DRIVE
REMOVAL
Drain the final gear oil and remove the rear wheel.
Remove the mounting nuts, and remove the final drive
assembly.
DRIVE SHAFT REMOVAL
W i t h Damper Case:
Hold the drive shaft in a soft jaw vise and separate the final
gear case from the drive shaft.
CAUTION
Use care w h e n clamping the damper case section of
the final drive assembly in a vise to avoid damaging
it.
Date of Issue: March,
1995
o
HONDA MOTOR CO..LTD.
15-5