Suspension; Dual Motion Type; Inspection For Side Stand With Ignition Cut-Off Switch - Honda Motorcycle Service Manual

MAINTENANCE
Dual Motion Type
The side stand should lower easily to its first stop, then lock
after moving farther forward to support the motorcycle as the
rubber touches the ground.
RETRACTED
When the motorcycle is lifted upright, the stand should
automatically move to the first position, and retract when kick-
ed up.
If the side stand does not move freely, disassemble it:
Remove the return spring at the retracted position.
Remove the pivot bolt and remove the side stand assembly
from the frame.
Check the following parts for wear or damage:
-
inside of the pivot and pivot collar
- pivot dust seals
Lubricate the pivot area with clean grease and reassemble the
side stand.
CAUTION
Install the dust seal with its mark side facing in.
.
Make sure that the dust seal spring is seated on the out-
side of the seal lips after installing the pivot collar.
Recheck the side stand movement.
Inspection For Side Stand With Ignition Cut-off Switch
Check the spring for damage or loss of tension.
Check the side stand assembly for freedom of movement.
Lubricate the pivot bolt and the side stand pivot area if
necessary
Tighten the pivot bolt and nut. Refer to the Model Specific
manual for specified torque.
Check the side stand ignition cut-off switch:
- Sit astride the motorcycle and raise the side stand.
- Start the engine with the transmission in neutral, then shift
the transmission into gear, with the clutch lever squeezed.
-
Move the side stand full down.
- The engine should stop as the side stand is lowered.
If there is a problem with the system, check the side stand
switch.
F
SUSPENSION
Compress the front and rear suspension a few times.
On models with exposed suspension springs, check for cracks
and damage.
Loose, worn, or damaged suspension parts impair vehi-
cle stability and control. Repair or replace any damaged
components before riding. Riding a vehicle with faulty
suspension increases your risk of an accident and possi-
ble injury.
- - -
Date of Issue : March, 1995
0
HONDA MOTOR CO.,LTD.