Pinch Bolt Type Removal; Pinch Bolt Type Installation; Double Holder Type Installation; Wheelsitires - Honda Motorcycle Service Manual

WHEELSITIRES
Installation
Place the front wheel between the fork legs
Set the brake disc between the brake pads carefully. Do not
damage the pads.
Slowly lower the front of the vehicle until the fork legs are
aligned with the axle.
Install the axle holders with the arrow pointing forward and the
speedometer gear box boss aligned with the fork leg stop.
Tighten the upper nuts or forward nuts first; then the lower or
rear nuts.
Reconnect the cables
PINCH BOLT TYPE
Removal
Loosen the axle pinch bolts on the axle bolt side and remove
the axle bolt.
Loosen the axle pinch bolts on the opposite side and remove
the axle while holding the wheel. Remove the front wheel.
Installation
Place the front wheel between the fork legs and work the
brake disc between the pads. Be careful not to damage the
pads.
Install the axle. Tighten the axle bolt to the specified torque.
Align the speedometer gear box stop with the fork leg stop.
NOTE
Make sure that the index line on the axle aligns with the
fork leg surface.
Tighten all the pinch bolts to the specified torque
Refer to the Model Specific manual for the proper torque
values.
Check the clearance between the brake disc and the caliper
bracket on each side after installation. The clearance should be
at least 0.7 mm 10.03 in).
If the clearance is not 0 . 7 mm ( 0 . 0 3 in) or more. loosen the
holder nuts or pinch bolt on the axle shaft side and adjust
the clearance. Then tighten the holder nuts or pinch bolt to
the specified torque.
PINCH BOLT
AXLE
BOLT
Date of issue: March.
1995
0
HONDA MOTOR CO..LTD.