Side Stand; Clutch Fluid Level; Conventional Type - Honda Motorcycle Service Manual

MAINTENANCE
Clutch fluid level
Adjustment for play cannot be made on hydraulic clutches.
However,
a
check should be made of the fluid level.
If the level is near the LOWER limit inscribed on the reservoir,
remove the reservoir cover and diaphragm, and refill to the UP-
PER level with the proper type of fluid.
Before removing the reservoir cover, turn the handlebar until
the reservoir is level.
Place a rag over painted, plastic or rubber parts whenever the
system is serviced.
CAUTION
/
.
Spilling fluid on painted, plastic or rubber parts
damaae them.
I
UPPER LEVEL LINE
Refill with the recommended fluid
CAUTION
efficiency.
Foreign materials can clog the system. causing a reduc-
tion or complete loss of clutch ability.
Replace
~t
~f
it
has become worn.
Support the motorcycle in an upr~ght and level posltlon, uslng
a support (use the center stand if ava~lablel.
SIDE STAND
Hook a spring scale t o the end of the s
check the load before the stand starts moving.
I
SIDE STAND RUBBER
Acceptable load measurements for side stands:
2-3 k g (4.4-6.6 lbsl (Road-type)
3-5 k g (6.6-11.0 lbsl (OnIOff Road type1
I
If the stand moves too easily, tighten the pivot bolt and
recheck. If it still does not have the required tension measure-
ment, replace the return spring.
See if the side stand moves smoothly and retracts fully.
If not, grease the pivot.
Check the side play on the side stand.
If it is too great tighten the pivot bolt.
Recheck and if it is still too great, replace the parts as
necessary.
I
SPRING SCALE