Pro-Arm Type (Center Lock Type) Removal; Pro-Arm Type (Center Lock Type) Installation - Honda Motorcycle Service Manual

WHEELSITIRES
PRO-ARM TYPE (CENTER LOCK TYPE)
Removal
Remove the cotter pin
NOTE
.
DO not reuse cotter pin.
- .
Using the main stand or equivalent, lift the rear wheel.
Remove the wheel nut, washer (if equipped), center lock
spacer and rear wheel.
Set the rear wheel t o touch the ground and loosen the wheel
nut applying the rear break.
Installation
Check the drive pin hole for damage and crack and clean the
contact surface of the rear wheel to the rear axle.
Apply grease to the axle center lock spacer and the contact
surface of the rear wheel
Install the rear wheel aligning the drive pin hole and the wheel
center hole.
WHEEL NUT
/
Date of Issue: March,1995
16-8
o
HONDA MOTOR
co
,LTD.