Honda Motorcycle Service Manual page 196

Make sure that the clutch lifter push rod is installed properly.
Install the dowel pins and a new gasket onto the slave cylinder
and install the cylinder by aligning the push rod with the oil seal
hole.
Tighten the mounting bolts to the specified torque.
I
VOTE
.
Some models have dowel bolts instead of dowel pins to
secure the slave cylinder positions.
.
Note the location of the dowel bolts or dowel pins for
positioning the slave cylinder.
.
Tighten the bolts in 2 or
3
steps in a crisscross pattern
starting from the dowel bolt or the dowel pin bolt.
Connect the clutch hose with the hose bolt and t w o new seal-
ing washers, then tighten the hose bolt to the specified torque.
Fill the clutch fluid reservoir and bleed the clutch system (page
11-28).
Date of Issue: Sep., 1988
O HONDA MOTOR CO., LTD.