Wheel/Hub Inspection; Bearing End Play; Wheel Runout - Honda CR-V 1997 Service Manual

Wheel/Hub Inspection
Bearing End Play
1. Raise the vehicle off the ground, and make sure it is
securely supported.
2. Remove the wheels, then reinstall the wheel nuts.
3, Attach the dial gauge as shown.
4. Measure the bearing end play by moving the disc or
drum inward or outward.
Front/Rear:
Standard: 0 - 0.05 mm (0 - 0.002 in)
Front:
108N·m
111.0 kgf·m. 80 Ibf.ftl
Rear:
Measure end play at center of
the hub flange.
Measure end play at the
hub flange.
108N·m
(11.0 kgf-m. 80 Ibl.ftl
5. If the bearing end play measurement is more than
the standard, replace the wheel bearing.
Wheel Runout
1. Raise the vehicle off the ground. and make sure it is
securely supported.
2. Check for bent or deformed wheels.
3. Attach the dial gauge as shown.
4. Measure the wheel runout by turning the wheel.
Front and Rear Wheel Axial Runout:
Standard:
Steel Wheel: 0 - t.O mm 10 - 0.04 in)
Aluminum Wheel: 0 - 0.7 mm (0 - 0.03 in)
Service Limit: 2.0 mm (0.08 in)
Front and Rear Wheel Radial Runout:
Standard:
Steel Wheel: 0- 1.0 mm (0 - 0.04 in)
Aluminum Wheel: 0 - 0.7 mm (0 - 0.03 in)
Service Limit: 1.5 mm (0.06 in)
)
~
5. If the wheel runout is more than the service limit,
replace the wheel.
18-7