Verifying The Interfaces And Directions On The Network Device - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual
Configuration guide
Hide thumbs
Also See for 4215 - Intrusion Detection Sys Sensor:
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Appendix C
Troubleshooting
-----------------------------------------------
cat6k-devices (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
router-devices (min: 0, max: 250, current: 1)
-----------------------------------------------
-----------------------------------------------
firewall-devices (min: 0, max: 250, current: 0)
-----------------------------------------------
-----------------------------------------------
sensor(config-net)#
Step 3
Manually connect to the device to make sure you have used the correct username, password, and enable
password, and to ensure that the device is reachable from the sensor.
a.
b.
c.
d.
Verify that each interface and direction on each network device is correct.
Step 4
For the procedure see
Verifying the Interfaces and Directions on the Network Device
To verify that each interface and direction on each controlled device is correct, you can send a manual
block to a bogus host and then check to see if deny entries exist for the blocked addresses in the router's
ACL.
You can also perform a manual block from IDM by clicking Monitoring > Active Host Blocks.
Note
78-16527-01
enable-password: <hidden>
password: <hidden>
username: netrangr default:
-----------------------------------------------
ip-address: 10.89.147.54
-----------------------------------------------
communication: telnet default: ssh-3des
nat-address: 0.0.0.0 <defaulted>
profile-name: r7200
block-interfaces (min: 0, max: 100, current: 1)
-----------------------------------------------
interface-name: fa0/0
direction: in
-----------------------------------------------
pre-acl-name: <defaulted>
post-acl-name: <defaulted>
-----------------------------------------------
-----------------------------------------------
-----------------------------------------------
Log in to the service account.
Telnet or SSH to the network device to verify the configuration.
Make sure you can reach the device.
Verify the username and password.
Verifying the Interfaces and Directions on the Network Device, page
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Troubleshooting the 4200 Series Appliance
C-19.
C-19
Advertisement
Table of Contents
Troubleshooting
