Logging In To Nm-Cids - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Configuration guide
Hide thumbs Also See for 4215 - Intrusion Detection Sys Sensor:
Table of Contents

Advertisement

Chapter 2
Logging In to the Sensor
Type your username and password at the login prompt:
Step 2
Note
login: cisco
Password:
***NOTICE***
This product contains cryptographic features and is subject to United States
and local country laws governing import, export, transfer and use. Delivery
of Cisco cryptographic products does not imply third-party authority to import,
export, distribute or use encryption. Importers, exporters, distributors and
users are responsible for compliance with U.S. and local country laws. By using
this product you agree to comply with applicable laws and regulations. If you
are unable to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
***LICENSE NOTICE***
There is no license key installed on the system.
Please go to http://www.cisco.com/go/license
to obtain a new license or install a license.
idsm-2

Logging In to NM-CIDS

You cannot access NM-CIDS through the router using the session command until you assign the internal
management port an IP address. You can do this either by assigning an IP address directly to the IDS
interface or by assigning an unnumbered loopback interface. If you do not set an IP address before you
session to NM-CIDS, you receive an error message.
After you assign the IP address, you can log in to NM-CIDS from the router console.
You must initialize the sensor (run the setup command) from the router. After networking is configured,
Note
SSH and Telnet are available.
78-16527-01
The default username and password are both cisco. You are prompted to change them the first
time you log in to IDSM-2.You must first enter the UNIX password, which is cisco. Then you
must enter the new password twice.
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Logging In to NM-CIDS
2-5

Advertisement

Table of Contents
loading

Table of Contents