Enabling And Disabling Telnet - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual
Configuration guide
Hide thumbs
Also See for 4215 - Intrusion Detection Sys Sensor:
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Changing Network Settings
-----------------------------------------------
To change the information back to the default setting, use the default form of the command:
Step 5
sensor(config-hos-net)# default host-ip
Verify that the host IP is now the default of 10.1.9.201/24,10.1.9.1:
Step 6
sensor(config-hos-net)# show settings
network-settings
-----------------------------------------------
-----------------------------------------------
sensor(config-hos-net)#
Step 7
Exit network settings mode:
sensor(config-hos-net)# exit
sensor(config-hos)# exit
Apply Changes:?[yes]:
Press Enter to apply the changes or type
Step 8
Enabling and Disabling Telnet
Use the telnet-option [enabled | disabled] command in the service host submode to enable Telnet for
remote access to the sensor. The default is disabled.
Caution
Telnet is not a secure access service and therefore is disabled by default. However, SSH is always
running on the sensor and it is a secure service.
To enable or disable Telnet services, follow these steps:
Log in to the sensor using an account with administrator privileges.
Step 1
Enter network settings mode:
Step 2
sensor# configure terminal
sensor(config)# service host
sensor(config-hos)# network-settings
Enable Telnet services:
Step 3
sensor(config-hos-net)# telnet-option enabled
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
4-4
-----------------------------------------------
ftp-timeout: 300 seconds <defaulted>
login-banner-text: <defaulted>
host-ip: 10.1.9.201/24,10.1.9.1 <defaulted>
host-name: sensor default: sensor
telnet-option: enabled default: disabled
access-list (min: 0, max: 512, current: 1)
-----------------------------------------------
network-address: 0.0.0.0/0
-----------------------------------------------
-----------------------------------------------
ftp-timeout: 300 seconds <defaulted>
login-banner-text: <defaulted>
to discard them.
no
Chapter 4
Initial Configuration Tasks
78-16527-01
Advertisement
Table of Contents
Troubleshooting
