Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 294

Catalyst and Cisco IOS Software Commands
• VACL configuration submode
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15-32
switchport capture
–
Sets the interface as a capture port.
switchport mode access
–
Sets the interface as an access port.
switchport mode trunk
–
Sets the interface as a trunk port.
switchport trunk allowed vlan vlans
–
Sets the allowed VLANs for trunk.
switchport trunk encapsulation dot1q
–
Sets dot1q as the encapsulation type.
switchport trunk native vlan vlan
–
Sets the native VLAN for the trunk port.
– action forward capture
Designates that matched packets should be captured.
match ip address [1-199 | 1300-2699 | acl_name]
–
Specifies filtering in the VACL.
Chapter 15 Configuring IDSM-2
78-16527-01