Configuring Idsm-2; Configuration Sequence - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Configuring IDSM-2

This chapter contains procedures that are specific to configuring IDSM-2.
Note Catalyst 6500 Series Switch is used generically to refer to both the 6500 series switches and the 7600
series routers.
This chapter contains the following sections:
•
•
•
•
•
•
•

Configuration Sequence

Perform the following tasks to configure IDSM-2:
1.
2.
3.
78-16527-01
Configuration Sequence, page 15-1
Verifying IDSM-2 Installation, page 15-2
Configuring the Catalyst 6500 Series Switch for Command and Control Access to IDSM-2,
page 15-4
Configuring the Catalyst Series 6500 Switch for IDSM-2 in Promiscuous Mode, page 15-7
Configuring the Catalyst Series 6500 Switch for IDSM-2 in Inline Mode, page 15-16
Administrative Tasks for IDSM-2, page 15-24
Catalyst and Cisco IOS Software Commands, page 15-27
Configure the Catalyst 6500 series switch for command and control access to IDSM-2.
For the procedure, see Configuring the Catalyst 6500 Series Switch for Command and Control
Access to IDSM-2, page 15-4.
Log in to IDSM-2.
For the procedure to session to the IDSM-2, see
Initialize IDSM-2.
Run the setup command to initialize IDSM-2.
For the procedure, see Initializing the Sensor, page
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15
C H A P T E R
Logging In to IDSM-2, page
3-2.
2-4.
15-1