Creating A Banner Login - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Administrative Tasks for the Sensor
This chapter contains procedures that will help you with the administrative aspects of your sensor. It
contains the following sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Creating a Banner Login

Use the banner login command to create a banner login that will be displayed before the user and
password login prompts. The maximum message length is 2500 characters. Use the no banner login
command to remove the banner.
To create a banner login, follow these steps:
Log in to the CLI using an account with administrator privileges.
Step 1
Enter global configuration mode:
Step 2
sensor# configure terminal
78-16527-01
Creating a Banner Login, page 13-1
Terminating CLI Sessions, page 13-2
Modifying Terminal Properties, page 13-3
Events, page 13-4
System Clock, page 13-7
Clearing the Denied Attackers List, page 13-8
Displaying Statistics, page 13-10
Displaying Tech Support Information, page 13-18
Displaying Version Information, page 13-19
Directing Output to a Serial Connection, page 13-21
Diagnosing Network Connectivity, page 13-22
Resetting the Appliance, page 13-23
Displaying Command History, page 13-24
Displaying Hardware Inventory, page 13-24
Tracing the Route of an IP Packet, page 13-25
Displaying Submode Settings, page 13-26
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
13
C H A P T E R
13-1