Unsupported Supervisor Engine Commands; Cisco Ios Software; Exec Commands - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Chapter 15 Configuring IDSM-2

Unsupported Supervisor Engine Commands

The following supervisor engine CLI commands are not supported by IDSM-2:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Cisco IOS Software

This section lists the Cisco IOS software commands that IDSM-2 supports. These commands are
grouped according to mode.
This section contains the following topics:
•
•
78-16527-01
set module [enable | disable] module_number
set port broadcast
set port channel
set port cops
set port disable
set port enable
set port flowcontrol
set port gmrp
set port gvrp
set port host
set port inlinepower
set port jumbo
set port membership
set port negotiation
set port protocol
set port qos
set port rsvp
set port security
set port speed
set port trap
set protocolfilter
set rgmp
set snmp
set spantree
set udld
set vtp
EXEC Commands, page 15-30
Configuration Commands, page 15-31
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Catalyst and Cisco IOS Software Commands
15-29