Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 97

Chapter 5 Configuring Interfaces
The following options apply:
default—Sets the value back to the system default setting.
•
idle-interface-delay—The number of seconds an interface must be idle before sending a
•
notification. The valid range is 5 to 3600. The default is 30 seconds.
missed-percentage-threshold—The percentage of packets that must be missed during a specified
•
interval before notification will be sent. The valid range is 0 to 100. The default is 0.
• notification-interval—Interval to check for missed packet percentage. The valid range is 5 to 3600.
The default is 30 seconds
To configure the interface notification settings, follow these steps:
Log in to the CLI using an account with administrator privileges.
Step 1
Enter global configuration mode:
Step 2
sensor# configure terminal
Enter interface submode:
Step 3
sensor(config)# service interface
Enter interface notifications submode:
Step 4
sensor(config-int)# interface-notifications
Configure the idle interface delay:
Step 5
sensor(config-int-int)# idle-interface-delay 60
Step 6 Configure the missed percentage threshold:
sensor(config-int-int)# missed-percentage-threshold 1
Step 7 Configure the notification interval:
sensor(config-int-int)# notification-interval 60
Verify the settings:
Step 8
sensor(config-int-int)# show settings
interface-notifications
-----------------------------------------------
-----------------------------------------------
sensor(config-int-int)#
Step 9 Exit interface notifications submode:
sensor(config-int-int)# exit
sensor(config-int)# exit
Apply Changes:?[yes]:
Step 10 Press Enter to apply the changes or type
78-16527-01
missed-percentage-threshold: 1 percent default: 0
notification-interval: 60 seconds default: 30
idle-interface-delay: 60 seconds default: 30
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
to discard them.
no
Configuring Interface Notifications
5-11