Viewing User Status - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Configuring User Parameters
Verify that the user's privilege has been changed:
Step 4
sensor(config)# exit
sensor# show users all
*
sensor#
The privilege of the user
Step 5 Display your current level of privilege:
sensor# show privilege
Current privilege level is administrator

Viewing User Status

Use the show users command to view information about the username and privilege of all users logged
in to the sensor, and all user accounts on the sensor regardless of login status.
An * indicates the current user. If an account is locked, the username is surrounded by parentheses. A
locked account means that the user failed to enter the correct password after the configured attempts.
The number of concurrent CLI sessions is limited based on platform. IDS-4210, IDS-4215, and
Note
NM-CIDS are limited to 3 concurrent sessions. All other platforms allow 10 sessions.
To view user information, follow these steps:
Log in to the CLI using an account with administrator privileges.
Step 1
Verify the users logged in to the sensor:
Step 2
sensor# show users
*
sensor#
Verify all users:
Step 3
sensor# show users all
*
sensor#
The account of the user
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
4-16
CLI ID User Privilege
13491 cisco administrator
jsmith operator
operator operator
service service
viewer viewer
jsmith
CLI ID User Privilege
13491 cisco administrator
CLI ID User Privilege
13491 cisco administrator
5824 (jsmith) viewer
9802 tester operator
jsmith
has been changed from
viewer
is locked.
Chapter 4 Initial Configuration Tasks
to .
operator
78-16527-01