Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 36

Logging In to NM-CIDS
To session to NM-CIDS, follow these steps
Assign an IP address to the management port:
Step 1
Assign an IP address directly to the IDS interface:
a.
router(config)# interface IDS-Sensor1/0
router(config-if)# ip unnumbered Loopback0
router(config-if)# exit
Assign an unnumbered loopback interface:
b.
router(config)# interface Loopback0
router(config-if)# ip address 1.2.3.4 255.255.255.255
router(config-if)# exit
The IP address can be any address that is not used anywhere else in the network.
Session to NM-CIDS through the router console:
Step 2
service-module IDS-Sensor slot_number/0 session
Type your username and password at the login prompt:
Step 3
Note
login: cisco
Password:
***NOTICE***
This product contains cryptographic features and is subject to United States
and local country laws governing import, export, transfer and use. Delivery
of Cisco cryptographic products does not imply third-party authority to import,
export, distribute or use encryption. Importers, exporters, distributors and
users are responsible for compliance with U.S. and local country laws. By using
this product you agree to comply with applicable laws and regulations. If you
are unable to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
***LICENSE NOTICE***
There is no license key installed on the system.
Please go to http://www.cisco.com/go/license
to obtain a new license or install a license.
nm-cids#
Press Ctrl-Shift-6, then x to get back to the router prompt if you sessioned to the router.
Step 4
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
2-6
The default username and password are both cisco. You are prompted to change them the first
time you log in to NM-CIDS. You must first enter the UNIX password, which is cisco. Then you
must enter the new password twice.
Chapter 2 Logging In to the Sensor
78-16527-01