Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 181
Configuration guide
Hide thumbs
Also See for 4215 - Intrusion Detection Sys Sensor:
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Chapter 10
Configuring Blocking
--MORE--
To return to the default value of 250 blocks:
Step 6
sensor(config-net-gen)# default block-max-entries
Verify the setting:
Step 7
sensor(config-net-gen)# show settings
general
-----------------------------------------------
--MORE--
Exit network access submode:
Step 8
sensor(config-net-gen)# exit
sensor(config-net)# exit
Apply Changes:?[yes]:
Press Enter to apply the changes or type
Step 9
78-16527-01
max-interfaces: 250 <defaulted>
master-blocking-sensors (min: 0, max: 100, current: 0)
-----------------------------------------------
-----------------------------------------------
never-block-hosts (min: 0, max: 250, current: 1)
-----------------------------------------------
ip-address: 11.11.11.11
-----------------------------------------------
-----------------------------------------------
never-block-networks (min: 0, max: 250, current: 1)
-----------------------------------------------
ip-address: 12.12.0.0/16
-----------------------------------------------
-----------------------------------------------
block-hosts (min: 0, max: 250, current: 0)
-----------------------------------------------
log-all-block-events-and-errors: true <defaulted>
enable-nvram-write: false <defaulted>
enable-acl-logging: false <defaulted>
allow-sensor-block: false default: false
block-enable: true <defaulted>
block-max-entries: 250 <defaulted>
max-interfaces: 250 <defaulted>
master-blocking-sensors (min: 0, max: 100, current: 0
-----------------------------------------------
-----------------------------------------------
never-block-hosts (min: 0, max: 250, current: 1)
-----------------------------------------------
ip-address: 11.11.11.11
-----------------------------------------------
-----------------------------------------------
never-block-networks (min: 0, max: 250, current: 1)
-----------------------------------------------
ip-address: 12.12.0.0/16
-----------------------------------------------
-----------------------------------------------
block-hosts (min: 0, max: 250, current: 0)
-----------------------------------------------
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
to discard them.
no
Configuring Blocking Properties
10-9
Advertisement
Table of Contents
Troubleshooting
