Administrative Tasks For Idsm-2; Enabling Full Memory Tests; Catalyst Software - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Administrative Tasks for IDSM-2

EtherChannel Load-Balancing Addresses Used Per-Protocol:
Non-IP: Source XOR Destination MAC address
IPv4: Source XOR Destination IP address
IPv6: Source XOR Destination IP address
MPLS: Label or IP
router#
To see IDSM-2 data port information:
Step 5
router# show intrusion-detection module module_number data-port data_port_number state
Intrusion-detection module 11 data-port 2:
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: dot1q
Negotiation of Trunking: Off
Access Mode VLAN: 662 (ward-victim3)
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: NONE
Pruning VLANs Enabled: 2-1001
Vlans allowed on trunk:none
Vlans allowed and active in management domain: none
Vlans in spanning tree forwarding state and not pruned:
none
Administrative Capture Mode: Disabled
Administrative Capture Allowed-vlans: empty
Administrative Tasks for IDSM-2
This section contains procedures that help you with administrative tasks for IDSM-2. It contains the
following topics:
•
•

Enabling Full Memory Tests

When IDSM-2 initially boots, by default it runs a partial memory test. You can enable a full memory test
in Catalyst software and Cisco IOS software. This section describes how to enable full memory tests,
and contains the following topics:
•
•

Catalyst Software

Use the set boot device boot_sequence module_number mem-test-full command to enable a full
memory test. The full memory test takes about 12 minutes.
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15-24
Enabling Full Memory Tests, page 15-24
Resetting IDSM-2, page 15-26
Catalyst Software, page 15-24
Cisco IOS Software, page 15-25
Chapter 15 Configuring IDSM-2
78-16527-01