Changing Network Settings - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Initial Configuration Tasks
This chapter contains procedures for the initial configuration tasks, such as changing sensor setup
information, adding and deleting users, configuring time and setting up NTP, creating a service account,
configuring SSH and TLS, and installing the license key.
This chapter contains the following sections:
•
•
•
•
•
•
•

Changing Network Settings

After you initialize your sensor, you may need to change some of the network settings that you
configured when you ran the setup command.
This section describes how to configure the network settings and, contains the following topics:
•
•
•
•
•
•
78-16527-01
Changing Network Settings, page 4-1
Changing Web Server Settings, page 4-9
Configuring User Parameters, page 4-11
Configuring Time, page 4-18
Configuring SSH, page 4-30
Configuring TLS, page 4-34
Installing the License Key, page 4-37
Changing the Hostname, page 4-2
Changing the IP Address, Netmask, and Gateway, page 4-3
Enabling and Disabling Telnet, page 4-4
Changing the Access List, page 4-5
Changing the FTP Timeout, page 4-7
Adding a Login Banner, page 4-8
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
4
C H A P T E R
4-1