Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 292

Catalyst and Cisco IOS Software Commands
EXEC Commands
The following commands are all performed in EXEC mode:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15-30
clock read-calendar
Updates the clock time to the calendar time.
clock set time date
Sets the current time and date.
clock update-calendar
Updates the calendar time to the clock time.
hw-module module slot_number reset
Resets IDSM-2 into the partition specified by the boot device variable; if the boot device variable
has not been set, IDSM-2 is reset to the application partition by default. Use the command show
boot device module module_number to view the current setting of the boot device variable.
hw-module module slot_number reset cf:1
Resets the module into the maintenance partition.
hw-module module slot_number shutdown
Shuts down the module so that it can be safely removed from the chassis.
reload
Reloads the entire switch.
session slot slot_number processor processor_number
Logs in to the console of IDSM-2 from the switch console.
show intrusion-detection module module_number data-port data_port_number state
Displays the state of the specified IDSM-2 data port.
show intrusion-detection module module_number data-port data_port_number traffic
Displays traffic statistics for IDSM-2 data port traffic.
show intrusion-detection module module_number management-port state
Displays the state of the IDSM-2 management port.
show intrusion-detection module module_number management-port traffic
Displays traffic statistics for the IDSM-2 management port.
show ip access-lists
Displays the current access lists.
show module
Displays the installed modules, versions, and states.
show running-config
Displays the configuration that is currently running.
show startup-config
Displays the saved configuration.
show vlan access-map
Displays all current VLAN access maps.
Chapter 15 Configuring IDSM-2
78-16527-01