Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 330

Installing System Images
Catalyst Software
To configure the IDSM-2 maintenance partition, follow these steps:
Log in to the switch CLI.
Step 1
Enter privileged mode:
Step 2
cat6k# enable
cat6k(enable)#
Session to IDSM-2:
Step 3
cat6k# session 9
Trying IDS-9...
Connected to IDS-9.
Escape character is '^]'.
Cisco Maintenance image
Note
Log in as user
Step 4
Note
login: guest
Password: cisco
Maintenance image version: 2.1(2)
guest@idsm2.localdomain#
View the IDSM-2 maintenance partition host configuration:
Step 5
guest@idsm2.localdomain# show ip
IP address
Subnet Mask
IP Broadcast
DNS Name
Default Gateway : 10.89.149.126
Nameserver(s)
guest@idsm2.localdomain#
Step 6 Clear the IDSM-2 maintenance partition host configuration (ip address, gateway, hostname):
guest@idsm2.localdomain# clear ip
guest@localhost.localdomain# show ip
IP address
Subnet Mask
IP Broadcast
DNS Name
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
17-28
You cannot Telnet or SSH to the IDSM-2 maintenance partition.You must session to it from the
switch CLI.
and password
guest
You can change the guest password, but we do not recommend it. If you forget the maintenance
partition guest password, and you cannot log in to the IDSM-2 application partition for some
reason, you will have to RMA IDSM-2.
: 10.89.149.74
: 255.255.255.128
: 10.255.255.255
: idsm2.localdomain
:
: 0.0.0.0
: 0.0.0.0
: 0.0.0.0
: localhost.localdomain
Chapter 17 Upgrading, Downgrading, and Installing System Images
.
cisco
78-16527-01