Interface Support - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Interface Support

The sensor detects the interfaces of modules that have been installed while the chassis was powered off.
You can configure them the next time you start the sensor. If a module is removed, the sensor detects the
absence of the interfaces the next time it is started. Your interface configuration is retained, but the
sensor ignores it if the interfaces are not present.
The following interface configuration events are reported as status events:
•
•
•
•
Interface Support
Table 5-1
Table 5-1
Base Chassis
IDS-4210
IDS-4215
IDS-4215
IDS-4235
IDS-4235
IDS-4235
IDS-4250
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
5-2
Link up or down
Traffic started or stopped
Bypass mode auto activated or deactivated
Missed packet percentage threshold exceeded
describes the interface support for appliances and modules running IPS 5.0:
Interface Support
Added PCI
Cards
—
—
4FE
—
4FE
TX (GE)
—
Interfaces Supporting
Inline
None
None
FastEthernet0/1
4FE
FastEthernet1/0
FastEthernet1/1
FastEthernet1/2
FastEthernet1/3
None
4FE
FastEthernet1/0
FastEthernet1/1
FastEthernet1/2
FastEthernet1/3
TX onboard + TX PCI
GigabitEthernet0/0 +
GigabitEthernet1/0 or
GigabitEthernet2/0
None
Chapter 5 Configuring Interfaces
Possible Port Interfaces Not
Combinations Supporting Inline
N/A All
N/A All
0/1<->1/0 FastEthernet0/0
0/1<->1/1
0/1<->1/2
0/1<->1/3
1/0<->1/1
1/0<->1/2
1/0<->1/3
1/1<->1/2
1/1<->1/3
1/2<->1/3
N/A All
1/0<->1/1 GigabitEthernet0/0
1/0<->1/2 GigabitEthernet0/1
1/0<->1/3
1/1<->1/2
1/1<->1/3
1/2<->1/3
0/0<->1/0 GigabitEthernet0/1
0/0<->2/0
N/A All
78-16527-01