Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 71

Chapter 4 Initial Configuration Tasks
-----------------------------------------------
Exit recurring summertime submode:
Step 10
sensor(config-hos-rec)# exit
sensor(config-hos)# exit
Apply Changes:?[yes]:
Press Enter to apply the changes or type
Step 11
Configuring Non-recurring Summertime Settings
Use the summertime-option non-recurring command to configure the sensor to switch to summer time
settings on a one-time basis. The default is recurring.
To configure the sensor to switch to summertime settings on a one-time basis, follow these steps:
Log in to the sensor using an account with administrator privileges.
Step 1
Enter summertime non-recurring submode:
Step 2
sensor# configure terminal
sensor(config)# service host
sensor(config-hos)# summertime-option non-recurring
Step 3 Enter start summertime submode:
sensor(config-hos-non)# start-summertime
Step 4 Configure the start summertime parameters:
a.
b.
c.
Enter end summertime submode:
Step 5
sensor(config-hos-non-sta)# exit
sensor(config-hos-non)# end-summertime
78-16527-01
-----------------------------------------------
Type the date you want to start summertime settings:
sensor(config-hos-non-sta)# date 2004-05-15
The format is yyyy-mm-dd.
Type the time you want to start summertime settings:
sensor(config-hos-non-sta)# time 12:00:00
The format is hh:mm:ss.
Verify your settings:
sensor(config-hos-non-sta)# show settings
start-summertime
-----------------------------------------------
date: 2004-05-15
time: 12:00:00
-----------------------------------------------
sensor(config-hos-non-sta)#
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
to discard them.
no
Configuring Time
4-25