Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 469

Appendix C Troubleshooting
Port
----- -------------------- ---------- ---------- ------ ----------- ------------
6/8
Port
----
6/8
Port
----- ---------- ---------- ---------- ---------- ---------
6/8
Port
----- ---------- ---------- ---------- ---------- --------- --------- ---------
6/8
Port
----- --------------------------
6/8
Idle Detection
--------------
--
cat6k> (enable)
For Cisco IOS software:
cat6k#show intrusion-detection module 5 management-port state
Intrusion-detection module 5 management-port:
Switchport: Enabled
Administrative Mode: dynamic desirable
Operational Mode: static access
Administrative Trunking Encapsulation: negotiate
Operational Trunking Encapsulation: native
Negotiation of Trunking: On
Access Mode VLAN: 1 (default)
Trunking Native Mode VLAN: 1 (default)
Trunking VLANs Enabled: ALL
Pruning VLANs Enabled: 2-1001
Vlans allowed on trunk:1
Vlans allowed and active in management domain: 1
Vlans in spanning tree forwarding state and not pruned:
1
Access Vlan = 1
cat6k#
Step 5 If the command and control port is not in the correct VLAN, put it in the correct VLAN.
For the procedure, refer to
Access to IDSM-2, page
78-16527-01
Name Status
connected
Status ErrDisable Reason
---------- -------------------
connected
Align-Err FCS-Err Xmit-Err
0 0
Single-Col Multi-Coll Late-Coll
0 0
Last-Time-Cleared
Wed Mar 2 2005, 15:29:49
Configuring the Catalyst 6500 Series Switch for Command and Control
15-4.
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Vlan Duplex Speed
trunk full
Port ErrDisableTimeout
----------------------
- Enable
Rcv-Err UnderSize
0 0 0
Excess-Col Carri-Sen Runts
0 0 0
Troubleshooting IDSM-2
Type
1000 IDS
Action on Timeout
-----------------
No Change
Giants
0 -
C-43