Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 52
Configuration guide
Hide thumbs
Also See for 4215 - Intrusion Detection Sys Sensor:
- Hardware installation manual (74 pages)
Table of Contents
Advertisement
Changing Network Settings
Add an entry to the access list:
Step 3
sensor(config-hos-net)# access-list 10.89.146.110/32
The netmask for a single host is 32.
Verify the change you made to the access-list:
Step 4
sensor(config-hos-net)# show settings
network-settings
-----------------------------------------------
-----------------------------------------------
Remove the entry from the access list:
Step 5
sensor(config-hos-net)# no access-list 10.89.146.110/32
Verify the entry has been removed:
Step 6
sensor(config-hos-net)# show settings
network-settings
-----------------------------------------------
-----------------------------------------------
sensor(config-hos-net)#
The host is no longer in the list.
Change the value back to the default:
Step 7
sensor(config-hos-net)# default access-list
Verify the value has been set back to the default:
Step 8
sensor(config-hos-net)# show settings
network-settings
-----------------------------------------------
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
4-6
host-ip: 10.1.9.201/24,10.1.9.1 <defaulted>
host-name: sensor <defaulted>
telnet-option: enabled default: disabled
access-list (min: 0, max: 512, current: 2)
-----------------------------------------------
network-address: 10.1.9.0/24
-----------------------------------------------
network-address: 10.89.146.110/32
-----------------------------------------------
-----------------------------------------------
ftp-timeout: 300 seconds <defaulted>
login-banner-text: <defaulted>
host-ip: 10.1.9.201/24,10.1.9.1 <defaulted>
host-name: sensor <defaulted>
telnet-option: enabled default: disabled
access-list (min: 0, max: 512, current: 1)
-----------------------------------------------
network-address: 10.1.9.0/24
-----------------------------------------------
-----------------------------------------------
ftp-timeout: 300 seconds <defaulted>
login-banner-text: <defaulted>
host-ip: 10.89.130.108/23,10.89.130.1
default: 10.1.9.201/24,10.1.9.1
host-name: sensor <defaulted>
telnet-option: enabled default: disabled
access-list (min: 0, max: 512, current: 0)
-----------------------------------------------
Chapter 4
Initial Configuration Tasks
78-16527-01
Advertisement
Table of Contents
Troubleshooting
