Supported Supervisor Engine Commands - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Catalyst and Cisco IOS Software Commands

Supported Supervisor Engine Commands

IDSM-2 also supports the following supervisor engine CLI commands, which are described in more
detail in the Catalyst 6500 Series Command References.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
15-28
clear config module_number
Clears the configuration on the supervisor engine that is associated with the specified IDSM-2.
clear log module_number
Deletes all entries in the error log for the specified IDSM-2.
session slot_number
Logs in to the console of IDSM-2 from the switch console.
set module commands (all other set module commands return an error message):
– set module name module_number
Sets the name of the module.
set module power module_number [up | down]
–
Enables or disables power to the specified IDSM-2.
set port name module_number
Configures the name for the specified IDSM-2 port.
set span
Configures port 1 as a SPAN destination port. You cannot use port 1 on IDSM-2 as a SPAN source
port.
set trunk
Configures trunk ports.
set vlan
Configures VLAN capture ports.
show config
Displays the supervisor engine NVRAM configurations.
show log
Displays the error logs for the specified IDSM-2.
show mac module_number
Displays the MAC counters for the specified IDSM-2.
show module module_number
With an IDSM-2 installed, displays "Intrusion Detection System Module" under Module-Type.
show port module_number
Displays the port status for the specified IDSM-2.
show port capabilities [module | module_number]
Displays the capabilities of the module and ports.
show test
Displays the errors reported from the diagnostic tests for both the SPAN port (port 1) and the
management port (port 2) and the BIOS and CMOS boot results.
Chapter 15 Configuring IDSM-2
78-16527-01