Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual page 255

Chapter 13 Administrative Tasks for the Sensor
-----------------------------------------------
cat6k-devices (min: 0, max: 250, current: 1)
-----------------------------------------------
-----------------------------------------------
router-devices (min: 0, max: 250, current: 1)
-----------------------------------------------
-----------------------------------------------
firewall-devices (min: 0, max: 250, current: 2)
-----------------------------------------------
-----------------------------------------------
sensor(config-net)#
Step 4 You can use the include keyword to show settings in a filtered output, for example, to show only profile
names and IP addresses in the Network Access Controller configuration:
sensor(config-net)# show settings | include profile-name|ip-address
sensor(config-net)#
78-16527-01
profile-name: 2admin
profile-name: r7200
profile-name: insidePix
profile-name: qatest
profile-name: fwsm
profile-name: outsidePix
profile-name: cat
profile-name: rcat
profile-name: nopass
profile-name: test
profile-name: sshswitch
ip-address: 10.89.147.61
ip-address: 10.89.147.54
ip-address: 10.89.147.10
ip-address: 10.89.147.82
profile-name: 2admin
profile-name: r7200
profile-name: insidePix
profile-name: qatest
profile-name: fwsm
profile-name: outsidePix
profile-name: cat
profile-name: rcat
profile-name: nopass
profile-name: test
profile-name: sshswitch
ip-address: 10.89.147.61
profile-name: cat
ip-address: 10.89.147.54
profile-name: r7200
ip-address: 10.89.147.10
profile-name: insidePix
ip-address: 10.89.147.82
profile-name: test
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
Displaying Submode Settings
13-29