Displaying The Current Configuration - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Working With Configuration Files
This chapter describes how to use commands that show, copy, and erase the configuration file. It contains
the following sections:
•
•
•
•
•
•
•
•

Displaying the Current Configuration

Use the show configuration or the more current-config command to display the contents of the current
configuration.
To display the contents of the current configuration, follow these steps:
Log in to the CLI.
Step 1
Display the current configuration:
Step 2
sensor# show configuration
! ------------------------------
! Version 5.0(0.22)
! Current configuration last modified Fri Dec 17 21:38:23 2004
! ------------------------------
service analysis-engine
exit
! ------------------------------
service authentication
exit
! ------------------------------
service event-action-rules rules0
exit
! ------------------------------
service host
network-settings
78-16527-01
Displaying the Current Configuration, page 12-1
Displaying the Current Submode Configuration, page 12-3
Filtering the Current Configuration Output, page 12-9
Filtering the Current Submode Configuration Output, page 12-11
Displaying the Contents of a Logical File, page 12-13
Copying and Restoring the Configuration File Using a Remote Server, page 12-15
Creating and Using a Backup Configuration File, page 12-17
Erasing the Configuration File, page 12-17
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
12
C H A P T E R
12-1