Verifying Etherchanneling - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Chapter 15 Configuring IDSM-2
To remove the whole EtherChannel:
Step 4
Note
router(config)# no intrusion-detection module port-channel channel_number

Verifying EtherChanneling

To verify the IDSM-2 EtherChannel configuration, follow these steps:
Log in to the console.
Step 1
Step 2 To see all EtherChannels:
router# show etherchannel
Group: 10
----------
Group state = L2
Ports: 0
Port-channels: 1 Max Port-channels = 1
Protocol:
cat6k#
To see specific EtherChannel status:
Step 3
router# show etherchannel 1 [summary | detail | port | port-channel | protocol]
Example:
router# show etherchannel 1 summary
Flags:
Number of channel-groups in use: 1
Number of aggregators:
Group
------+-------------+-----------+----------------------------
router#
Step 4 To see the EtherChannel load balance setting:
router# show etherchannel load-balance
EtherChannel Load-Balancing Configuration:
78-16527-01
The VACL capture commands for IDSM-2 will be left.
Channel-group listing:
-----------------------
Maxports = 8
-
D - down P - in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
u - unsuitable for bundling
Port-channel Protocol
src-dst-ip
mpls label-ip
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
1
Ports
Configuring EtherChanneling
15-23