Installing The Aip-Ssm System Image - Cisco 4215 - Intrusion Detection Sys Sensor Configuration Manual

Installing System Images
Cisco IOS Software
To upgrade the maintenance partition, follow these steps:
Download the IDSM-2 maintenance partition file (c6svc-mp.2-1-1.bin.gz) to the FTP root directory of
Step 1
a FTP server that is accessible from your IDSM-2. For the procedure for locating software on Cisco.com,
see
Step 2 Log in to the switch CLI.
Step 3 Session in to the application partition CLI:
router# session slot slot_number processor 1
Step 4 Enter configuration mode:
idsm2# configure terminal
Upgrade the maintenance partition:
Step 5
idsm2(config)# upgrade
ftp://user@ftp_server_IP_address/directory_path/c6svc-mp.2-1-1.bin.gz
Specify the FTP server password:
Step 6
Password: ********
You are prompted to continue:
Continue with upgrade?:
Step 7 Type

Installing the AIP-SSM System Image

You can reimage the AIP-SSM in one of the following ways:
•
•
•
To install the AIP-SSM system image, follow these steps:
Log in to the ASA.
Step 1
Enter enable mode:
Step 2
asa> enable
Configure the recovery settings for AIP-SSM:
Step 3
asa# hw-module module 1 recover configure
Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.0
17-36
Obtaining Cisco IPS Software, page
to continue.
yes
From ASA using the hw-module module 1 recover configure/boot command. See the following
procedure.
Recovering the application image from the sensor's CLI using the recover application-partition
command. For the procedure, see
Upgrading the recovery image from the sensor's CLI using the upgrade command. For the
procedure, see Upgrading the Recovery Partition, page
Chapter 17 Upgrading, Downgrading, and Installing System Images
18-1.
Recovering the Application Partition, page
17-4.
17-9.
78-16527-01