Honeywell EK205-M Operating Instructions Manual page 59

Data transfer
Only enable the test time window for battery operation for as long as is required. Each
time the test time window is open, this reduces the life of the EK205-M battery.
i
The editable time window is not directly reflected in the forecast of the remaining
battery life of the batteries" BatR" of the EK205-M. Therefore, the forecast battery life
is not changed if the time window is changed. Past time windows and data transfers
are however used in the remaining battery capacity "BatRK" and remaining service life
forecast calculation.
b) Display GSM field strength
−
Check whether corresponding bars indicating the reception level for the internal modem ("i")
appear on the main EK205-M display.
−
Move the cursor to the "Serv." tab in the EK205-M's display, then to
Interfaces > internal modem > GSM and GPRS > GSM.L
−
The percentage field strength is now displayed under GSM.L.
−
In order to update the level display, move the cursor to GSM.L, please press the
the EK205-M and then wait approx. 30 seconds. This makes it possible to determine the best
installation position for an external GSM antenna.
i
With a field strength below 50% data transfer issues may be encountered. You can
remedy this in the majority of cases with the external antenna, mounted somewhere
suitable.
8.1.4.3 Retrieving data with enSuite
a) Opening the test time window for the following test retrievals with enSuite
i
The test time window only needs to be open if none of the time windows 1 to 4 are
open.
−
If the communication link to the EK205-M via the optical interface is not set up, it must be
created.
( section
−
Select "Navigation" on the left-hand side of the enSuite window and then
at the bottom of the navigation window.
−
In the top of the device window open the path "Parameters" > "Interfaces" by clicking on the
relevant plus signs, and then select
−
Click on the "0" value next to
window and enter a duration in minutes (i.e. 10), for the test time window for the test retrieval to
remain open. For a battery-operated EK205-M please do not enter an excessively long
duration, as this will adversely affect the battery life.
−
Press the "Transfer changes to
The EK205-M is now available via the modem for the duration set.
−
In enSuite press the "Disconnect" icon or
interface communication link between enSuite and the EK205-M.
b) Test retrieval via the modem
−
Set up the modem communication link (=GPRS12 connection) between enSuite and EK205-M.
( section 7.2 Setting up the communication link to EK205-M via a modem, p. 5050)
12
CSD=Circuit Switched Data, line switched data service in the case of mobile telephony
7.1 Setting up the communication link to the EK205-M via optical
"Test call acceptance
device" icon at the top of the enSuite window.
"internal modem" (not the plus sign before).
window" in the right-hand side of the
"Disconnect from all
ENTER
interface, p. 50)
"Parameterize
devices" to terminate the optical
59
key of
online"