Table of Contents
Advertisement
Safety
individuals concerned have already worked with such a device or a similar one or were
instructed by the manufacturer.
◼
Knowledge of the content is one of the requirements of protecting staff from hazards and
avoiding faults and therefore operating the device in a safe and fault-free manner.
◼
In order to avoid risks and to ensure that the device performs in an optimal manner, no
changes or modifications that were not expressly authorized by the manufacturer may be
performed to the device.
◼
Always keep all operating instructions on the device in easily legible condition. Renew
damaged or illegible instructions.
◼
Observe settings values or value ranges stated in the instructions.
3.2
Intended use
The device is designed and constructed exclusively for its intended use as described here.
The Volume Conversion Device EK205-M serves to convert a gas volume of a
gas line in basic condition measured by a meter in measurement conditions as
well as to assign the volumes measured to tariffs. In addition, using the device,
further parameters can be measured, recorded, and monitored depending on
the configuration set by the user.
Compliance with all the specifications in these operating instructions also falls under the device's
intended use. Any use of the device that goes beyond or deviates from its intended use is
considered a misuse of the device and may lead to hazardous situations. Claims of any kind due
to loss resulting from non-intended use of the device are excluded.
WARNING!
Hazard from incorrect use!
Incorrect use of the device may result in hazardous situations.
Therefore:
– Use the device only as intended.
– Do not use the device to control the gas flow or other parameters influencing the
gas volume within the framework of the overall system.
3.3
Specific Conditions of Use
◼
The equipment must be only connected to a certified associated intrinsically safe
equipment. This combination must be compatible as regards the intrinsically safe rules.
◼
Only temperature or pressure sensor defined in the manufacturer's technical file can be
used.
19
Advertisement
Table of Contents
