Table of Contents
Advertisement
2． Backup Power Supervision
Backup power fault supervision can be enabled by setting the power amplifier's DIP switch.
Switch No. Function
2
3． Power-saving Mode
To ensure a long backup period in case of a back-up power failure, the INTEVIO system can
work in power-saving mode. In this mode, all the non-emergency functions are disabled, all
power amplifiers are switched off but ready for operation again and are woken up regularly for
power amplifier monitoring.
Power-saving settings must also be made in the configuration tool to have proper functionality.
System Hardware Checking
To avoid damage from incorrect connection, carefully check the following:
1． Check the power connection of all devices, especially those with AC backup power. Note that
the polarity should match.
2． Check the connection of the system extension circuit and the end device should be connected
to the EOL resistor.
3． Check the wiring connection from the RK-MCU and the zone expander to the power amplifier.
4． Check the wiring connection between the backup power amplifier and related devices.
5． Check the wiring connection from the RK-MIC to the RK-MCU and the connection between the
RK-MICs. Note that the end device should be connected to the end resistor.
6． To avoid short circuit, ensure there is no burr on the wire terminal.
7． Check all the settings for the device addresses and work mode.
8． Check the connection of the loudspeaker lines.
Do not apply power to the power supply before all checks are complete. For power supply information,
please refer to "Power On & Off".
System Basic Information
Please pay attention to the following information before configuring the system.
Below is the default setting of RK-MCU:
No.
Description
1
System ID
2
IP address
3
Subnet mask
4
Gateway address
5
Device password
6
Time zone
For more parameters, such as a device's IP address, subnet mask, gateway, firmware version, etc.,
users can view them through the menu "View System Information".
Description
Backup power
supervision
Parameter
10000
192.168.2.200
255.255.255.0
192.168.2.1
8888
+8
ON——Enabled
OFF——Disabled
54
Advertisement
Table of Contents
