Operations; Power On & Off; Reset; Ack - Honeywell INTEVIO User Manual

Buttons/Switches
Button/Switch
All
Close
Monitor CH1
Monitor CH2
Record
Playback
Line in
Microphone
Programmable
buttons

Operations

Power On & Off
There is a power switch on the rear panel of each device to connect or disconnect the AC power
supply. After installation, press the power switch to the "I" position to turn on the device, and press
the power switch to the "O" position to turn off the device.

Reset

All the fault statuses of the system can be cleared manually by pressing the RESET button on the
front panel of the RK-MCU. If the fault still exists, the device will show a notification again.
If the fire alarm reset mode is configured as "Manual-Reset" or "Manual-Duration-Reset", users need
to press the RESET button to clear the alarm status after a fire alarm.
Please refer to RK-MCU reset for setting the button to "System Reset".

ACK

When system detects any new fault, the buzzer of the RK-MCU will beep. Meanwhile, the general
fault indicator will turn yellow and start flashing to notify operators. The operator can press the "ACK"
button on the front panel of the MCU to confirm the fault, then the buzzer will be muted and the
general fault indicator will be constantly yellow.
When the system receives new fire alarm signals, it will enter emergency mode and the buzzer of
the RK-MCU will continue to beep. Press the ACK button to mute the buzzer.

Test

Test function is used to check the light and sound indicators. The following are the steps for test
operation:
1． Press the TEST button on the front panel of the MCU to start test function. The test will not affect
other functions. During the test:
- All indicators will forcibly light up, the multi-color indicator will flash different colors in turn.
- The screen displays red, green, and blue in turn.
- Buzzer sounds.
Action Description
Press Select all zones.
Press Forcibly close selected zones.
Press Monitor or stop monitoring CH1.
Press Monitor or stop monitoring CH2.
Press Start or stop temporary recording.
Press Play temporary recording file in the built-in loudspeaker.
Press Start or stop broadcasting the audio source from line in.
Press Start or stop live broadcast.

Select or deselect zone or group.

Press Start or stop broadcasting audio source.

Increase or decrease volume.
98