Front Adapter Cage Replacement - Lenovo ThinkSystem SR665 V3 User Manual

• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the CMOS battery.
Note: Before you install the battery into the socket, make sure that the positive side faces upward.
Figure 36. Installing the CMOS battery
a. Tilt the battery and insert it to the positive end on the socket. Make sure that the battery
goes tight to the metal clip.
b. Press the battery down until it clicks into the socket.
After you finish
1. Complete the parts replacement. See
2. Use the Setup utility to set the date, time, and any passwords.
Demo video
Watch the procedure on YouTube

Front adapter cage replacement

Follow instructions in this section to remove and install the front adapter cage, including the riser 5 cage at
the top and the front OCP cage at the bottom.
• "Remove the front adapter cage" on page 82
• "Install the front adapter cage" on page 86
and "Safety inspection checklist" on page 48
62.
"Complete the parts replacement" on page 279.
.
Chapter 5 Hardware replacement procedures
to ensure that you
81