Remove The Front 3.5-Inch Drive Backplane - Lenovo ThinkSystem SR665 V3 User Manual

Figure 73. Installing the 24-bay expander backplane
a. Align the bottom of the backplane with the slots on the chassis, and lower the backplane
into the chassis.
b. Rotate the backplane to the vertical position. Align the holes in the backplane with the pins
on the chassis, and press the backplane into position. The release tabs will secure the
backplane in place.
Step 3. Connect the cables to the drive backplane. See
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See
2. Reinstall the fan cage. See
3. Reinstall the air baffle if you have removed it. See
4. Complete the parts replacement. See
5. If you have installed an AnyBay backplane with U.3 NVMe drives for Trimode, enable U.3 x1 mode for
the selected drive slots on the backplane through the XCC Web GUI. See
detected in NVMe connection, but cannot be detected in Tri-mode" on page
Demo video
Watch the procedure on YouTube

Remove the front 3.5-inch drive backplane

Follow instructions in this section to remove the front 3.5-inch drive backplane.
ThinkSystem SR665 V3 User Guide
116
"Install the system fan cage" on page
"Install the air baffle" on page
"Complete the parts replacement" on page
Chapter 6 "Internal cable routing" on page
"Install a hot-swap drive" on page
270.
"U.3 NVMe drive can be
281.
134.
72.
279.
514.