Lenovo ThinkSystem SR665 V3 User Manual page 103

Install the front OCP module
Follow instructions in this section to install the front OCP module.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Remove the OCP module filler if there is.
Step 3. Install the front OCP module.
Figure 50. Installing the front OCP module
a. Push the OCP module into the slot until it is fully seated.
b. Tighten the thumbscrew to secure the OCP module. Use a screwdriver if needed.
and "Safety inspection checklist" on page 48
62.
.
Chapter 5 Hardware replacement procedures
to ensure that you
93