Integrated Diagnostics Panel - Lenovo ThinkSystem SR665 V3 User Manual

You can also use the Lenovo XClarity Controller or a remote management program to change the state of the
system ID LED to assist in visually locating the server among other servers.
If the XClarity Controller USB connector is set to have both the USB 2.0 function and XClarity Controller
management function, you can press the system ID button for three seconds to switch between the two
functions.
System error LED (yellow)
4
The system error LED helps you to determine if there are any system errors.
Status Color
On Yellow
None
Off

Integrated diagnostics panel

The integrated diagnostics panel is attached to the front of the server, while it allows quick access to system
information such as errors, system status, firmware, network, and health information.
• "Diagnostics panel location" on page 479
• "Diagnostics panel overview" on page 480
• "Options flow diagram" on page 480
• "Full menu list" on page 481
Diagnostics panel location
Description
An error has been detected on the server.
Causes might include but are not limited to
the following errors:
• A fan failure
• A memory error
• A storage failure
• A PCIe device failure
• A power supply failure
• A processor error
• A system I/O board or processor board
error
The server is off, or the server is on and is
working correctly.
Action
• Check the Lenovo XClarity Controller
event log and the system event log to
determine the exact cause of the error.
• Check if additional LEDs elsewhere in the
server are also lit that will direct you to the
source of the error. See
by system LEDs and diagnostics display"
on page 476.
• Save the log if necessary.
None.
The handle with which the panel can be pulled out and
1
inserted into the server.
Notes:
• The panel can be inserted or pulled out regardless of
the system status.
• When pulling out the panel, carefully hold it by the
handle and avoid any hard pulling.
Chapter 8
"Troubleshooting
.
Problem determination
479