Cable Wall Bracket Replacement; Remove The Cable Wall Bracket - Lenovo ThinkSystem SR665 V3 User Manual

2. Reconnect the cables of the M.2 backplane if you have disconnected them. See
cable routing" on page
3. Reinstall the GPU adapter if you have removed it. See
4. Complete the parts replacement. See
Demo video
Watch the procedure on YouTube

Cable wall bracket replacement

Follow instructions in this section to remove and install the 2U cable wall bracket.
Your server comes with 1U cable wall brackets at both side of the processor board. For a configuration with
more than four cables routed at one side, a 2U cable wall bracket needs to be added onto the 1U cable wall
bracket for cable routing.
• "Remove the cable wall bracket" on page 75
• "Install the cable wall bracket" on page 76

Remove the cable wall bracket

Follow instructions in this section to remove the 2U cable wall bracket.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b. Remove the top cover. See
c. Remove any parts that might impede your access to the cable wall bracket.
d. Record all the cables that are passing through the cable wall bracket and disconnect them.
Step 2. Remove the 2U cable wall bracket.
281.
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 48
62.
"Remove the top cover" on page
"Install a GPU adapter" on page
"Remove the server from rack" on page
277.
.
Chapter 5 Hardware replacement procedures
Chapter 6 "Internal
129.
279.
to ensure that you
63.
75