Figure 139. Installing a performance heat sink
a.
Align the triangular mark and screws on the heat sink with the triangular mark and threaded
posts on the processor socket; then install the heat sink on the processor socket.
b.
Fully tighten all the screws in the installation sequence shown on the heat-sink label.
After you finish
1. Install the system fan cage if you have removed it. See
2. Complete the parts replacement. See
Demo video
Watch the procedure on YouTube
Rack latches replacement
Follow instructions in this section to remove and install the rack latches.
Note: Depending on the model, the left rack latch might be assembled with a VGA connector and the right
rack latch might be assembled with the front I/O module.
•
"Remove the rack latches" on page 184
•
"Install the rack latches" on page 187
Remove the rack latches
Follow instructions in this section to remove the rack latches.
About this task
Attention:
ThinkSystem SR665 V3 User Guide
184
"Install the system fan cage" on page
"Complete the parts replacement" on page
270.
279.