Lenovo ThinkSystem SR665 V3 User Manual page 195

• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b. If the server is installed with the security bezel, remove it first. See
on page 245.
c. Remove the top cover. See
d. Remove the air baffle. See
Step 2. Disconnect the VGA cable, the front I/O module cable, or both cables from the system board
assembly.
Notes:
• If you need to disconnect cables from the system board assembly, disengage all latches or
release tabs on cable connectors first. Failing to release the tab before removing the cables will
damage the cable sockets on the system board assembly. Any damage to the cable sockets
might require replacing the processor board or system I/O board.
• The connectors on your system board assembly might look different from those in the
illustration, but the removal procedure is the same.
1. Press the release tab to release the connector.
2. Disengage the connector from the cable socket.
Figure 140. Disconnecting cables from the system board assembly
and "Safety inspection checklist" on page 48
62.
"Remove the top cover" on page
"Remove the air baffle" on page
"Remove the server from rack" on page
"Remove the security bezel"
277.
70.
.
Chapter 5 Hardware replacement procedures
to ensure that you
63.
185