Figure 153. Installing the supercap holder
a.
Align the keyhole on the supercap holder with the pin on the chassis, and lower the supercap
holder into the chassis.
b.
Slide the supercap holder in the shown direction until it clicks into place.
Step 3.
Install the RAID flash power module.
Figure 154. Installing the RAID flash power module on the supercap holder
a.
Insert the RAID flash power module into the retaining clip at one side as shown.
b.
Press the RAID flash power module down on the other side until it snaps into place.
Step 4.
Connect the RAID flash power module to an adapter with the extension cable that comes with the
RAID flash power module. See
After you finish
Chapter 6 "Internal cable routing" on page
281.
.
Chapter 5
Hardware replacement procedures
193