Front I/O Module Replacement - Lenovo ThinkSystem SR665 V3 User Manual

Step 3. Connect the cables to the drive backplane. See
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See
2. Reinstall the fan cage. See
3. Reinstall the air baffle if you have removed it. See
4. Complete the parts replacement. See
Demo video
Watch the procedure on YouTube

Front I/O module replacement

Follow instructions in this section to remove and install the front I/O module.
The front I/O module varies by model. The front I/O module for most models is on the right rack latch. The
front I/O module on media bay is supported only in the following server models:
• Server models with eight 2.5-inch front drive bays
• Server models with sixteen 2.5-inch front drive bays
Front I/O module (on rack latch)
Depending on the server model, the server might come with one of the following front I/O module on media
bay:
ThinkSystem SR665 V3 User Guide
120
"Install the system fan cage" on page
"Install the air baffle" on page
"Complete the parts replacement" on page
Chapter 6 "Internal cable routing" on page
"Install a hot-swap drive" on page
270.
Front I/O module (on media bay)
281.
134.
72.
279.