Remove A Raid Flash Power Module From The Middle 2.5-Inch Drive Cage - Lenovo ThinkSystem SR665 V3 User Manual

c. Press it down to secure it into the holder.
Step 3. Connect the RAID flash power module to an adapter with the extension cable that comes with the
RAID flash power module. See
After you finish
Complete the parts replacement. See
Demo video
Watch the procedure on YouTube

Remove a RAID flash power module from the middle 2.5-inch drive cage

Follow instructions in this section to remove a RAID flash power module (also called supercap) from the
middle 2.5-inch drive cage.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b. Remove the top cover. See
c. Disconnect the cable of the RAID flash power module.
Step 2. Remove the rubber on the cover of the supercap holder.
ThinkSystem SR665 V3 User Guide
196
Chapter 6 "Internal cable routing" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 48
62.
"Remove the top cover" on page
281.
279.
"Remove the server from rack" on page
277.
to ensure that you
63.