Lenovo ThinkSystem SR665 V3 User Manual page 201

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board assembly), drive backplanes or drive cables, back up all important data that is stored
on drives.
Procedure
Step 1. Make preparation for the task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b. Remove the top cover. See
c. Remove the system fan cage. See
d. Disconnect the cable of the RAID flash power module.
Step 2. Remove the RAID flash power module.
Figure 151. Removing the RAID flash power module from the supercap holder
a. Open the retention clip on the supercap holder.
b. Take the RAID flash power module out of the holder.
Step 3. Remove the supercap holder as shown if necessary.
62.
"Remove the top cover" on page
"Remove the system fan cage" on page
"Remove the server from rack" on page
277.
.
Chapter 5 Hardware replacement procedures
63.
269.
191