Lenovo ThinkSystem SR665 V3 User Manual page 234
Hide thumbs
Also See for ThinkSystem SR665 V3:
- System configuration manual (80 pages) ,
- User manual (256 pages)
Table of Contents
Advertisement
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
• If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand
via the operating system.
Procedure
Step 1.
Make preparation for the task.
a.
If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b.
Remove the top cover. See
c.
Disconnect cables from the rear drive backplane.
d.
Remove all the installed drives and fillers (if any) from the drive bays. See
drive" on page
Step 2.
Remove the rear drive cage.
Figure 192. Removing the 4 x 3.5-inch rear drive cage
a.
Twist and pull out the blue plungers.
b.
Slide the drive cage towards the rear of the chassis to release it, and lift the drive cage out
of the chassis.
Step 3.
Remove the rear drive backplane.
ThinkSystem SR665 V3 User Guide
224
"Remove the top cover" on page
133.
"Remove the server from rack" on page
277.
"Remove a hot-swap
63.
Advertisement
Table of Contents
