Cage; Install The 4 X 3.5" Drive Backplane And Drive Cage - Lenovo ThinkSystem SR665 V3 User Manual

Figure 193. Removing the 4 x 3.5-inch rear drive backplane
a. Open the release latches in the direction as shown.
b. Rotate the backplane from the top to disengage it from the pins on the drive cage.
c. Carefully lift the backplane out of the drive cage.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube

Install the 4 x 3.5" drive backplane and drive cage

Follow instructions in this section to install the 3.5-inch 4-bay drive backplane and drive cage.
About this task
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• The rear drive cage is supported on some server models with thermal requirements. See
on page 59 to ensure that the server is under permitted ambient temperature and the correct heat sink
and system fans are used. If needed, replace your heat sink or system fan first.
– "Processor and heat sink replacement (trained technician only)" on page 175
and "Safety inspection checklist" on page 48
62.
.
Chapter 5 Hardware replacement procedures
to ensure that you
"Thermal rules"
225