Hot-Swap Drive Replacement - Lenovo ThinkSystem SR665 V3 User Manual

c. Install the riser 3 assembly. See
d. Open the blue latch on the GPU air baffle and fix the end of the GPU adapter. Then, close the
blue latch.
Step 7. (Optional) If a riser card is not installed with a GPU adapter, install a filler on the GPU air baffle.
Figure 93. Installing the GPU air baffle filler
After you finish
Complete the parts replacement. See

Hot-swap drive replacement

Follow instructions in this section to remove and install a hot-swap drive. You can remove or install a hot-
swap drive without turning off the server, which helps you avoid significant interruption to the operation of
the system.
• "Remove a hot-swap drive" on page 133
• "Install a hot-swap drive" on page 134
Notes:
• The term "hot-swap drive" refers to all the supported types of hot-swap hard disk drives, hot-swap solid-
state drives, and hot-swap NVMe drives.
• Use any documentation that comes with the drive and follow those instructions in addition to the
instructions in this topic. Ensure that you have all the cables and other equipment that are specified in the
documentation that comes with the drive.
• The electromagnetic interference (EMI) integrity and cooling of the server are protected by having all drive
bays covered or occupied. The vacant bays are either covered by an EMI-protective panel or occupied by
drive fillers. When installing a drive, save the removed drive filler in case that you later remove the drive
and need the drive filler to cover the place.
• To avoid damage to the drive connectors, ensure that the top cover is in place and fully closed whenever
you install or remove a drive.
ThinkSystem SR665 V3 User Guide
132
"Install a rear riser assembly" on page
"Complete the parts replacement" on page
242.
279.