The OCP module provides two or four extra Ethernet connectors for network connections. By default, any of
the connectors on the OCP module can function as a shared management connector.
Top view
This section contains information on the top view of the server.
The following illustration shows the top view of the server without any air baffle, middle cage, or rear cage
installed.
Figure 9. Server top view
Table 19. Component identification (Top view)
Front backplane(s)
1
System fans
3
Processors and heat sinks
5
System board assembly
7
Notes:
1. The illustration shows the server rear configuration with three riser assemblies. The server rear
configurations vary by server model. For details, see
2. The illustration shows the server with CFF adapters which are available only in the 2.5-inch chassis. In
some configurations, there might be installed with a RAID flash power module. For details, see
"Location of RAID flash power modules" on page
Intrusion switch
2
Memory modules
4
Riser assemblies
note 1
6
CFF RAID adapter/expander
8
"Rear view" on page
190.
note 2
24.
Table 25
.
Chapter 2
Server components
29